PEER-REVIEWED PUBLICATION

2026

Decellularized skin enriched with methacrylated hyaluronic acid enhances cell adhesion and accelerates wound closure

A tensile test divider icon

Platania V, Tsanaktsidou E, Kammona O, Chatzinikolaidou M

Biomaterials Science

University of Crete, Centre for Research and Technology Hellas, Foundation for Research and Technology Hellas

RESEARCH SUMMARY
This study developed a bioactive dermal patch by coating decellularized bovine dermis with photocrosslinked methacrylated hyaluronic acid (MeHA) to improve the mechanical stability, hydration behavior, cell adhesion, and wound-healing performance of decellularized skin scaffolds. Bovine dermis was decellularized using Triton X-100 and SDS, preserving the collagen-rich extracellular matrix while removing approximately 99.8% of the original DNA. The resulting dDerm was infiltrated with 1% MeHA and photocrosslinked, with 405 nm curing selected for subsequent experiments because it produced a more uniform hydrogel coating approximately 17 ± 5 µm thick. MeHA functionalization reduced swelling from approximately 576% for unmodified dDerm to 316%, while also improving hydrolytic stability: mass loss after 21 days in PBS decreased from 59% for dDerm to 34% for MeHA-Derm. Uniaxial tensile testing showed that decellularization reduced stiffness relative to native bovine dermis, with Young’s modulus decreasing from approximately 200 MPa to 100 MPa. MeHA functionalization substantially reinforced the decellularized matrix, increasing Young’s modulus to approximately 500 MPa. HaCaT keratinocytes showed high viability on both scaffolds, with MeHA-Derm supporting greater cell density, metabolic activity, and focal adhesion maturation. Vinculin intensity was significantly higher on MeHA-Derm at days 5 and 10, indicating stronger cell-matrix adhesion. In an in vitro scratch assay, MeHA-Derm accelerated early keratinocyte migration compared with unmodified dDerm and tissue-culture plastic. In an ex vivo wound model, MeHA-Derm achieved 42 ± 13% closure by day 3 versus 22 ± 18% for dDerm, 82 ± 12% versus 43 ± 25% by day 5, and 92 ± 4% versus 84 ± 14% by day 10. Overall, the study demonstrates that a thin photocrosslinked MeHA interface can mechanically reinforce decellularized dermal extracellular matrix while preserving its native architecture and improving keratinocyte adhesion, migration, and wound-closure behavior, supporting further development of the composite as a dermal substitute for regenerative wound care.
CellScale hexagons, without text

CELLSCALE INSTRUMENT USED

UniVert

A CellScale UniVert mechanical tester was used to perform uniaxial tensile testing on native bovine dermis, decellularized bovine dermis, and MeHA-functionalized decellularized dermal patches. Rectangular specimens were dried before mechanical characterization, mounted between pneumatic grips, and stretched at a crosshead speed of 1.66 mm/s until 25% strain, with five independent specimens tested per group. Stress-strain curves were recorded and used to calculate Young’s modulus and ultimate tensile strength from the linear region of the response. UniVert testing showed that decellularization reduced the stiffness of bovine dermis, with Young’s modulus decreasing from approximately 200 MPa for native Derm to approximately 100 MPa for dDerm. Addition and photocrosslinking of the MeHA coating substantially reinforced the matrix, increasing Young’s modulus to approximately 500 MPa. The MeHA-Derm stress-strain response also exhibited a steeper elastic region and reduced ductility relative to native and decellularized dermis, consistent with reinforcement by the crosslinked surface network. These UniVert measurements provided the primary quantitative evidence that MeHA functionalization restores and substantially increases the dry-state tensile stiffness of the decellularized dermal scaffold. The authors subsequently related this mechanically reinforced interface to enhanced keratinocyte attachment and focal adhesion maturation, while emphasizing that the tensile measurements were performed on dried constructs and therefore should not be interpreted as the effective modulus of the patch in the hydrated wound environment.
AUTHORS

Varvara Platania, Evgenia Tsanaktsidou, Olga Kammona, Maria Chatzinikolaidou.

PUBLICATION DETAILS
JOURNAL

Biomaterials Science

YEAR

2026

INSTITUTIONS

University of Crete, Centre for Research and Technology Hellas, Foundation for Research and Technology Hellas

COUNTRIES

Greece

INSTRUMENT USED

UniVert

TESTING METHODS

Tensile Testing

RESEARCH APPLICATIONS

ECM & Decellularized Matrix MechanicsScaffold Mechanical TestingSkin and Wound Healing Biomechanics

Related Publications:

Instrument Used:
Year:
Testing Method:
Research Application:
Country:

Reduced cortical bone strength and altered osteocyte canaliculi despite preserved bone mass in male Becn1+/− mice

Pei Q, Qin X, He Y, et al.

Bone

UniVert

Flexural and Bending Testing

Bone Tissue Engineering & Mechanics

2027

Preparation of hydrophobic semi-transparent regenerated cellulose composite membranes reinforced by low-cost ground calcium carbonate

Zhang Y, Jiang X, Yuan M, et al.

Food Packaging and Shelf Life

UniVert

Tensile Testing

Membranes and Thin Films MechanicsPolymers and Elastomers Testing

2026

A multifunctional graphene-integrated double-network nanocomposite hydrogel for dual strain-temperature wearable sensing

Romih A, Abdul Samad Y, Kim JK, Schiffer A

Advanced Composites and Hybrid Materials

UniVert

Adhesion TestingCompression TestingFatigue TestingTensile Testing

Adhesives and Sealants TestingHydrogel Mechanical TestingMaterial Fatigue and DurabilityStimuli Responsive Hydrogels CharacterizationWearable Bioelectronics

2026

Contact Sales

Product of Interest:
CellScale hexagon shapes