A CellScale MicroTester G2 was used to mechanically characterize individual electrospun polyurethane fibers under dry, acutely submerged, and four-day water-soaked conditions. Single fibers were harvested onto custom 3D-printed collectors and mounted directly on the MicroTester. A 0.1016 mm diameter steel MicroTester beam was positioned near the center of each fiber, creating the study’s three-point loading configuration. Before testing, a 0.4% pre-strain was applied to ensure that the fiber was initially in tension. Dry fibers were tested in air after 24 hours of drying, submerged fibers were tested in a water bath after approximately one hour of total water exposure, and soaked fibers were immersed for four days before being tested in a water bath. All specimens underwent the same sequential cyclic loading protocol, consisting of two loading cycles each to 10%, 15%, 20%, and 30% strain. Fibers were loaded at 11 µm/s and unloaded at 22 µm/s, with each full experiment lasting approximately 30 minutes. Force and displacement were derived from the known stiffness and measured deflection of the MicroTester steel beam. These measurements revealed nonlinear strain stiffening, hysteresis, and cycle-dependent damage across all hydration states. Fiber stiffness increased strongly with strain, while prolonged water soaking shifted the response toward lower average stiffness and peak force, reduced damage-related energy dissipation, and increased the relative contribution of viscous behavior. MicroTester data were also decomposed into elastic, viscous, and damage energy components and fitted with a quasi-linear visco-hyperelastic damage model, allowing the authors to quantify hydration-dependent changes in shear modulus, strain-stiffening behavior, damage evolution, viscous modulus, and relaxation time. The MicroTester measurements therefore provided the experimental foundation for both the fiber-scale mechanical characterization and the constitutive model developed for predictive multiscale modeling of electrospun polyurethane biomaterials.